HP SPECTRE X360 is not an improvement in Hamilton New Zealand Charing – Applefix & Tech Engineers

Repair of New Zealand Hamilton Laptops

Repair of the new secton selandia new spectra hp

The HP Specter laptop is on, on the battery power but does not charge the power adapter. Type C DC Jack Broken Pads Repair. Laptop repair experts in Hamilton New Zealand call 078394111 or visit 937 Victoria Street Hamilton New Zealand. Visit our website www.applefix.co.nz to send instructions to read your device here https://applefix.co.nz/send-your-dove/

General Guide for Replacement of Type C Filling Port Below

Solder Port Type-C Filling Port on the X360 HP Specter requires the right precision and tools. Because the USB-C port is installed on the surface (SMD), an improper soldering can damage the motherboard. The following guide step by step:

Tools & Materials needed:

Solder iron (preferred that is controlled by temperature, set to 300-350 ° C)

Solder Wire (Recommended Guided, Flux-core)

Flux (fluid fluid or paste for better solder flow)

Desoldering Tool (Solder Wick, Desoldering Pump)

Hot air re -work station (to remove the old port)

Tweezers & magnifying glass (for proper placement)

Isopropyl alcohol & brushes (for cleaning)

Multimeter (to check continuity after repair)

Replacement of USB-C ports (exactly the original model)

Solder Steps-Demi-Stepping Guide:

1. Unloading a laptop

Turn on the laptop, remove the battery (if possible), and remove all resources.

Open the back panel carefully (check ifixit or manual HP service for your model).

Find the USB-C port on the motherboard.

2. Remove the damaged USB-C port

Apply the flux around the port solder connection.

Use a hot air station (~ 350 ° C) to heat the port evenly until the solder melts.

Lift the port gently with tweezers after the liquid solder.

Clean the remaining solder with the solder axis and desoldering pump.

3. Prepare PCB bearings

Clean the bearing with alcohol isopropyl.

Check a damaged or lifted bearing – if something is missing, you may need a jumper cable.

Apply a little fresh solder to the bearing for a better adhesion.

4. Solder New USB-C Port

Place a new port in position (align perfectly with a cushion).

Secure one corner with a small amount of solder first.

The remaining solder pin is carefully using the Solder-Tips Iron.

For multip-pin ports, drag solder with flux helps avoid bridges.

5. Check & test

Check the solder bridge (use an enlargement).

Clean excess flux with isopropyl alcohol.

Continuity test with a multimeter (check CC, VBus, GND, etc.).

The peak returns to the laptop and data filling/data transfer test.

General Problems & Repair:

No charging? → Check VBus (5V) and Pin CC for continuity.

Loose connection? → Solder Reflow Connection with Flux.

Short circuit? → Find a solder bridge and clean it with a solder axis.

Warning:

⚠️ ESD Safety: Use anti-static wrist straps.

⚠️ Hot control: too much heat that can damage the motherboard.

⚠️ Skills Level: If you are not experienced, consider professional improvement.